RSW-Wired Short Arm Smart Wind Transducer Installation Instructions
Let’s Go!
How to navigate this document
Legal notices
Important information
Safety warnings
Product installation and operation
Switch off power supply
Potential ignition source
Working at height
Product warnings
Product grounding
12 Volt dc only
Regulatory notices
Disclaimer
Warranty policy and registration
Declaration of Conformity
PSTI Compliance
Product disposal
IMO and SOLAS
Technical accuracy
Publication copyright
Document information
Applicable products
Document information
Document conventions
Document illustrations
Product documentation
Operation instructions
Display software
Product and system overview
Product overview
Smart Wind Transducer compatibility
System example
Parts supplied
Parts supplied
Additional components
Product dimensions
Product dimensions — Wind transducer
Product dimensions — Gateway
Location requirements
Warnings and cautions
Wind transducer location requirements
Gateway location requirements
Installation
Tools required
Mast cable routing
Mast cable drip loop
Mounting the wind transducer
Mounting the gateway
Potential ignition source
Cables and connections — General information
General cabling guidance
Cable types and length
Cable routing and bend radius
Strain relief
Circuit isolation
Cable shielding
Connections overview
Connecting cables
Power connection
SeaTalk NG power supply
Inline fuse and thermal breaker ratings
SeaTalk NG power cables
SeaTalk NG product loading
SeaTalk NG power connection point
SeaTalk NG system loading
Power distribution — SeaTalk NG
12 Volt dc only
Product grounding
Positive ground systems
Power connection via Autopilot Control Unit (ACU-Series)
Ground connection
Gateway ground connection
Connections
Connecting the wind transducer
Cutting the cable
Connecting mast cable to the gateway
Connecting the gateway to the network
Configuration
RSW-Series wind transducer configuration
Configuring RSW wind using LightHouse 4 display
Configuring the RSW-Series wind transducer using i70 / i70s instrument display
RSW-Series wind transducer internal compass calibration
Resetting compass calibration (LightHouse 4)
Resetting compass calibration (i70 / i70s)
Maintenance
Service and maintenance
Routine equipment checks
Troubleshooting
Troubleshooting
Wind data troubleshooting
LED diagnostic guidance
LED diagnostics
Technical support
Raymarine technical support and servicing
Viewing product information
Remote Support via AnyDesk
Learning resources
Technical specification
Physical specification
Power specification
Environmental specification
Conformance specification
Spares and accessories
Spares
GNSS (GPS) receiver accessories
Heading sensor accessories
Transducer accessories
SeaTalk NG cables and accessories
Software release history
Supported NMEA 2000 PGNs
