Tools required

The following tools are required for installation.

  1. Cordless drill.

  2. Pozi-drive screw driver.

  3. Suitable sized drill bit for mounting the Wind transducer.

  4. Suitable sized drill bit for mounting the Gateway.

  5. 5 mm (13⁄64 in) drill bit (for mast cable routing).

  6. Wire cutters.

  7. Pencil or marker.

Note

Drill bit sizes for mounting holes must be a suitable size for the fixings, the mounting surface material type and the mounting surface thickness (e.g.: a 4 mm (5⁄32 in) drill bit should be used when mounting the wind transducer on an aluminium surface).