Connections ContentsConnecting the wind transducerFollow the steps below to connect the wind transducer’s cable to the connector on the supplied mast cable.Cutting the mast cableOnce the mast cable has been fully routed, cut off any excess cable and prepare the wires for connection to the gateway.Connecting mast cable to the gatewayThe bare-ended wires on the supplied mast cable should be connected to the gateway after the mast cable has been routed to the gateway. The wire connections on the gateway are color-coded to match the mast cable wire colors.Connecting the gateway to the networkThe gateway must be connected to a SeaTalk NG / NMEA 2000 network.Previous topic: Ground connectionNext topic: Configuration