User interface (settings) ContentsCAM400 User interfaceThe CAM400 includes a built-in user interface, which can be used to view the camera’s video feed and configure the camera’s settings.Live view pageThe LIVE VIEW page provides the live video feed being received from the camera.Navigation paneThe user interface is navigated using the expandable Navigation pane located on the left side of the camera’s settings pages.System information pageThe System information page provides settings and information related to the system and network .electronic regulatory labels (E-Labels) are also available.Camera SettingThe Camera Setting page provides settings to adjust the video feed image.Stream FormatThe Stream Format page provides settings to adjust the camera’s video streams.Motion DetectionThe Motion Detection page is used to configure the camera’s motion detection alarm.Password ChangeThe password used to log in to the user interface can be changed.User AccountAdditional users accounts can be created, each with a unique ID and Password. for accessing the user interface.Network SettingThe Network Setting page is used to view and configure the camera’s IPv4 and IPv6 addresses.DNSThe DNS page is used to view and configure the DNS servers the camera uses.NTPIf enabled the NTP page is used to view and configure the Network Time Protocol (NTP) that the camera will use to automatically obtain date and time.RTSPThe RTSP page is used to view and configure the camera’s RTSP streams.Port SettingThe Port Setting page is used to view and configure the ports the camera will use for streaming and control.IP FilterThe IP Filter page enables you to allow or block access to specific IP addresses or ranges of IP addresses.System UpgradeThe System Upgrade page can be used to check the camera’s current firmware version and perform firmware upgrades.System RestartThe System Restart page is used to manually restart the camera or configure the camera to automatically restart at a specified time on specified days..Factory DefaultThe Factory Default page is used to reset the camera to its factory default settings.Date / TimeThe Date / Time page is used to specify the camera’s Time Zone. If an NTP server has not been configured, this page can also be used to manually set the camera’s date and time.System LogsThe System Logs page is used to view, search and delete system logs.Previous topic: Setup and operation via PC / laptopNext topic: Augmented Reality