Installation ContentsTools requiredThe following tools are required to install and connect a YachtSense DCS-Series Digital Control System to a vessel’s electrical system.Camlock systemInput and output modules and power supply modules include a camlock system that is used to lock the modules together. The camlock system consists of 3 camlocks on each module, one on the front and 2 on the rear. The modules are supplied with the camlocks in the unlocked position.Removing covers and fusesBefore assembling the Master and Remote systems the fuses covers and fuses should be removed.Assembling Master or Remote systemsThe method for assembling Master systems and Remote systems is the same.Mounting optionsDepending on module configuration Master and Remote systems can be mounted with or without the included mounting bracket.Fitting the mounting bracketMaster systems and Remote systems are supplied with a mounting bracket and rear shim. Systems that contain more than 4 input / output modules require the mounting bracket and rear shim to be fitted to a module in the middle of the system assembly.Mounting system assemblies using the bracketFollow the steps below to mount Master system assembly and Remote system assemblies that include 4 or more input / output modules.Mounting without the bracketFollow the steps below to mount a Master system assembly and Remote system assemblies that include less than 4 input / output modules..Mounting using the mounting templateA supplied mounting template can aid installation in confined or difficult to reach places.Previous topic: Location requirementsNext topic: Cables and connections — General information