Autopilot integration ContentsAutopilot control overviewYour performance display can be integrated with an Evolution-Series autopilot system and act as the autopilot’s controller while connected to a Raymarine LightHouse 4 (v4.7.172 or later) multifunction display / chartplotter. Refer to the documentation supplied with your autopilot for details on installation, commissioning and connecting your autopilot to your multifunction display / chartplotter network.Pilot standby modeThe Pilot: STANDBY mode is the default mode that the Autopilot control page preset will automatically change to while your autopilot is disengaged.Steer to HeadingIn Steer to Heading mode, your autopilot follows a locked heading.Steer to NavigationThe Steer to Navigation mode causes your autopilot to turn and navigate to a selected waypoint / cursor goto location or along a planned route.Steer to wind modesSteer to wind modes use your autopilot’s Wind vane mode to steer your vessel to the wind. You can steer either to the Apparent Wind Angle (AWA), True Wind Angle (TWA) or to a target wind angle from a polar table.Disengaging the autopilotTo disengage the autopilot using your performance display, either:Unsupported modesThe following autopilot modes are not supported by the Alpha-Series performance display:Disabled settingsPrevious topic: Widget creation and customizationNext topic: Operation via Raymarine multifunction display