Mounting preparation ContentsTools requiredThe following tools are recommended for installation:Rear access requirementsAccess to the rear of the display and mounting surface is required to surface and flush mount the display.Mounting optionsThe displays can be mounted flush with the mounting surface (flush mount) or with the glass protruding from the mounting surface (surface mount).Preparing the mounting surface — surface mountingSurface mounting requires one cut out hole. When the display is surface mounted the glass/bezel will protrude from the mounting surface.Preparing the mounting surface — flush mountingFlush mounting requires the same cut out hole as surface mounting and an additional rebate around the edge of the cut out. When the display is flush mounted, the glass will be flush with the mounting surface.Fitting the gasket tapeBefore fitting the display you must fit the mounting gasket tape to the rear of the display, as shown below.Previous topic: Location requirementsNext topic: Mounting