Routing the cable

Always use the supplied cable clips to secure the transducer cable to the transom. If the cable will be routed through the transom, use the escutcheon plate to cover the hole.

Routing the cable

1. Plan the route your cable will take to the MFD or sonar module.

   For cable routing guidance, refer to: Transducer cable routing guidance

2. If required, drill a 25 mm (1 inch) hole in the transom at the desired location to route the cable through.
3. If required, drill 25 mm (1 inch) holes through any bulkheads that you want to route the cable through.
4. Round off the edges of any holes using a file to avoid damaging the cable on any sharp burrs.
5. Route the transducer cable to the MFD or sonar module, connecting any necessary extension cables.
6. Secure the cable to the transom using the supplied cable clips and screws.

   For detailed instructions, refer to: Securing the cable

7. Where applicable, cover the hole in the transom using the supplied escutcheon plate.

   For detailed instructions, refer to: Mounting the escutcheon plate