Securing the cable

Use the supplied cable clips and screws to secure the transducer cable to the transom.

Note

After applying marine grade sealant, always allow time for the sealant to fully cure before returning your vessel to the water.

Securing the cable
  1. When placing the first cable clip, ensure there is sufficient slack in the transducer cable to allow the transducer to tilt up and down.
  2. Drill a pilot hole at the desired location.
  3. Attach the cable clip to the cable.
  4. Apply marine grade sealant to the thread of the cable clip screw.
  5. Push the screw through the mounting hole in the cable clip.
  6. Insert the screw into the pilot hole and tighten.
  7. Pull the cable so that it is tight, ready for the next cable clip.
  8. Cable clipsRepeat steps 2 to 7 for all cable clips.