Axiom 2 7" flush mounting instructions, using the pre-fitted trunnion
adaptor (supplied with all Axiom 2 7" display
variants).
InstallationFlush mountingTrunnion adapterMountingFlush mountingTrunnion adapterFlush mountingTrunnion adapter
Important
The supplied gasket provides a seal between the display and
a suitably flat and rigid mounting surface or binnacle. The gasket
should be used in all installations. It may also be necessary
to use a marine-grade sealant if the mounting surface or binnacle
is not entirely flat and / or has a rough surface finish.
In above decks installations, marine-grade sealant should always
be used to seal the gap between the edge of the mounting surface and
the edge of the display.
- Ensure that the pre-fitted trunnion adaptor has been removed
from the rear of the display in accordance with the instructions provided
in the following section:
- Ensure that the mounting surface has been prepared for
flush mounting in accordance with the instructions provided in the
following section:
- Route the relevant cables to the area behind the mounting
surface cut-out.
This may be difficult or not possible once the display has
been mounted.
- Screw the 4 x supplied M5x58 threaded studs into the rear
of the display.
- Remove the backing from the supplied gasket and place the
sticky side of the gasket onto the flange on the rear of the display.
Press firmly onto the flange.
- If required, insert your MicroSD card into the card reader
which is located behind the rubber bung on the rear of the display.
- Connect the relevant cables to the rear of the display.
- Slide the display into the cut-out area.
- Place the trunnion adaptor over the rear of the display.
- Secure the display in position by placing the 4x supplied
M5 thumb nuts onto the threaded studs and then hand-tightening until
secure.
Important To prevent potential damage to the
unit, do NOT overtighten the thumb nuts. Hand tighten only.
