After making any necessary adjustments to achieve
optimum performance for your vessel, the transducer installation must
be finalized by locking the transducer’s position.
Note After you apply marine grade sealant, always allow
time for the sealant to fully cure before returning your vessel to
the water.
Finalizing mounting
- Drill the hole for the final locking screw, taking care
not to damage the mounting bracket.
- Apply marine grade sealant to the screw thread.
- Insert and tighten the third ‘locking’ screw.
- Carefully remove the 2 x screws in the adjustment slots.
- Apply marine grade sealant to the screw threads.
- Re-insert and tighten the screws.
- Fully tighten the nut and bolt.
Do not exceed a torque of 35 N·m (25.8 lbf·ft). The transducer
should not be easily moveable by hand, and should remain in its normal
operating position when your vessel is underway.
