Alarm settings

Alarms are used to alert you to a danger, a hazard or a situation requiring your attention. Your performance display is capable of acting as a repeater for alarms raised by the multifunction display / chartplotter on your system. Once an alarm is triggered, the audio buzzer built into your performance display will sound.

SettingsAlarm

In order for an alarm to be raised on your performance display, the alarm must be separately enabled on both your multifunction display / chartplotter and your performance display.

Alarms can be enabled or disabled on your multifunction display / chartplotter via the Alarms page: Homescreen > Alarms > Settings.

The following alarms can be toggled either on or off for the performance display:

Category	Alarm(s)
AIS	AIS connection lost Dangerous AIS target Lost AIS target AIS safety messages AIS hardware alarm
Anchor	Anchor drift Deep anchor Shallow anchor
Battery	A toggle is available for each battery that is detected by your performance display. For more information, refer to: Battery data (Battery name) — battery (number)
DSC alarms	DSC alarms
Depth	Deep water Shallow depth Fishing zone arrival
Engine alarms	Engine alarms
Generator alarms	Generator alarms
Low fuel remaining	Low fuel remaining
Man overboard (MOB)	Man overboard (MOB) Note The Man overboard (MOB) alarm is enabled by default.
Navigation	Waypoint arrival Position lost Off track Interception arrival Position drift
Pilot alarms⁽¹⁾	Pilot alarms ⁽¹⁾
Radar	Dangerous Radar target Lost Radar target Guard zone 1 Guard zone 2
Speed	Boat speed high Boat speed low
Temperature	Water temperature high Water temperature low If an AX8 camera is connected to the same system as your performance display, an additional temperature toggle will be available. AX8 camera temperature
Wind	AWS high AWS low AWA high AWA low TWS high TWS low TWA high TWA low

Note

⁽¹⁾ Pilot alarms will be automatically enabled and locked once the Autopilot control page has been created.