Tools required

The following tools are required to install your transducer.

Tools requiredInstallationTools

  1. Power drill

  2. 2 x 14 mm (9/16”) wrenches or small adjustable wrenches.

  3. Pozi-drive screw driver

  4. Drill bit (suitable for pilot holes)

    Note

    The size of the drill bit required should be suitable for the fixings screws and the material and thickness of the mounting surface. Please refer to the parts supplied list for the fixing screws provided.

  5. Marine-grade neutral cure polyurethane sealant (non-acetate and non-silicone based)

  6. 25 mm (1 inch) Hole saw (only required if you are routing the cable through the transom and / or a bulkhead.)

  7. Masking or Adhesive tape (Used to fix the mounting template to the mounting surface)