Radar scanner initial power on test

Once all cables have been connected, it’s important to perform an initial power on test, to confirm correct operation.

Ensure that all cables have been correctly and securely connected to both the pedestal and a compatible multifunction display (which should initially be powered OFF):

  1. Ensure the pedestal’s Power/Safety switch is set to ON.
  2. Power on the multifunction display.

    The magnetron warm-up sequence should start, after which the Radar scanner should enter Standby mode.

  3. If necessary, adjust the brightness and contrast on the multifunction display, before proceeding with a Radar test, using the display’s Radar app.
Note

For information on performing a Radar test in the Radar app, refer to: Opening the Radar app