Routing the cable through a stepped deck mast

Follow the steps below to route cable through a stepped deck mast.
You will require new 1/8th spade terminals to perform this procedure.
  1. Remove the existing spade terminals from the end of the cable.
  2. Feed the cable down the mast and out through a suitable above-decks aperture.
  3. Fit a suitable cable gland to the deck.
  4. Pass the cable through the gland and run it back to the display or converter.
  5. Crimp the new spade terminals (not supplied) to the end of the cable.
  6. Connect the new spade terminals to the relevant connectors on the unit.