Commissioning — SPX and SmartPilot systems ContentsSPX and SmartPilot autopilot installationPilot responseCommissioningPowering on and offThe p70s / p70Rs automatically powers on when power is supplied to the network it is connected to, unless it has been powered off using the Standby button.Using the Set-up WizardThe set-up wizard guides you through the steps for setting important preferences, such as preferred language and correct vessel type.Dockside calibrationThe dockside calibration process must be completed before your SPX autopilot system can be used for the first time. The Dockside wizard guides you through the steps required for dockside calibration.Dealer settingsThe dockside calibration wizard is only available on a SeaTalk NG system. For SeaTalk systems, the Dealer settings should be set before going out on the water.Adjusting the hard-over time — SmartPilot and SPXOn vessels without a rudder reference transducer, it is important to set a Hard Over Time.Sea trial calibrationBefore you can use the autopilot open water checks are required. The water must be calm, with light or no wind. Leave plenty of room to manoeuvre. The Sea Trial wizard guides you through the steps required for Sea trial calibration.Checking autopilot operationAfter completing calibration, check the basic autopilot operation, as follows:Previous topic: Commissioning — Evolution autopilot systemNext topic: Autopilot modes