Post-installation checks

These checks should be carried out after installation, and prior to the commissioning of the autopilot system.
System ChecksPost-installation
  1. Switch on power to the autopilot system and any associated equipment.

    • ACU-Series unit.

    • Autopilot controller.

    • SeaTalk NG backbone (if this has its own power supply).

  2. Check to ensure that the autopilot controller powers up. If the display is blank, press and hold the Power button for 2 seconds.
  3. Check to ensure that the EV-1, ACU-Series unit and autopilot controller have the latest software installed. For more information, visit: https://bit.ly/rym-software
  4. Check the display for error messages that could indicate a problem with the installation.
  5. Check the LED status indications for the EV-1. For more information, refer to: LED indications
  6. If the fault persists and cannot be rectified, contact your dealer or Raymarine product support.