Power connection

The supplied power cable is connected to the POWER | VIDEO 2 | AUDIO connector located on the rear of the display. The power cable must then be connected to a 12 V dc or 24 V dc power supply; this can be achieved by connecting to a distribution panel, or directly to a battery. The product is protected against reverse polarity.

Power connectionConnectionsPower

  1. Display’s POWER | VIDEO 2 | AUDIO connector.

  2. Power/video/audio cable, 1.5 m (4.9 ft).

  3. Positive (Red) wire: connect to the power supply’s positive (+) terminal.

  4. Fuse.

  5. Negative wire: connect to the power supply’s negative (-) terminal.

  6. Drain wire: connect to RF ground point. If no ground point is available, connect to the battery’s negative (-) terminal.

Note

  • Axiom® 2 XL displays are supplied with a Power/video/audio cable that has a right-angled connector. A straight connector cable is also available (A80744).

  • The original Axiom® Power/Video/NMEA 0183 cables cannot be used with Axiom® 2 XL displays.