Initial power-on test
Once the unit has been correctly installed, conduct
an initial test to check that it is operating as intended.
PowerInitial test
The unit takes less than one minute to start up after being powered on. As the unit transitions from a state of powering on through to normal operation, the LED status indicator on the unit changes from solid to blinking green. If the LED status indicator is not blinking green, refer to the troubleshooting section of this handbook.
Open the Fishfinder application on your connected MFD / chartplotter, and ensure that it is operating correctly.
The following screenshot shows a typical 3D sonar view, with the sonar module operating normally:
