General location requirements

When selecting a location for your product it is important to consider a number of factors.

Location requirementsGeneralFactors for consideration:

• VentilationVentilation — To ensure adequate airflow:

  • Ensure that product is mounted in a compartment of suitable size.

  • Ensure that ventilation holes are not obstructed. Allow adequate separation of all equipment.

• Mounting surface — Ensure product is adequately supported on a secure surface. Do not mount units or cut holes in places which may damage the structure of the vessel.

• Cabling — Ensure the product is mounted in a location which allows proper routing, support and connection of cables:

  • Minimum bend radius of 100 mm (3.94 in.) unless otherwise stated.

  • Use cable clips to prevent stress on connectors.

  • If your installation requires multiple ferrites to be added to a cable then additional cable clips should be used to ensure the extra weight of the cable is supported.

• Water ingress — The product is NOT protected against the ingress of moisture or liquids. The product should be located in a protected area away from moisture and exposure to rain and salt spray.

• Electrical interference and noise — Select a location that is far enough away from devices that may cause interference, such as motors, generators and radio transmitters / receivers. Avoid the use of sub-standard sources of electrical power which may generate ripple or radiated noise, such as poor quality DC regulators or converters.

• Power supply — Select a location that is as close as possible to the vessel’s DC power source. This will help to keep cable runs to a minimum.