Restoring settings

SettingsConfiguration restoration

Note

  • If you have more than one Alpha Series performance display connected to your system, you will need to backup and restore each unit individually.

  • The screen size and orientation of your performance display must match the screen size and orientation of the performance display which the backup file was created from.

To restore your page configurations and system settings:

  1. Insert a MicroSD card (which contains your backup file) into a card reader slot on your multifunction display or a card reader (e.g. RCR-2) which has been connected to your multifunction display.
  2. Navigate to: Data page view > Overlay menu > Settings > Backup & restore.
  3. Select Restore from a backup.
  4. Select the multifunction display which your MicroSD card has been inserted into.
  5. Select the MicroSD card where the backup is stored.

    If no MicroSD card has been detected by your multifunction display, a ‘No SD card detected’ prompt will appear.

  6. Navigate the file browser and select either the root file directory of your MicroSD card or a (sub)folder on your MicroSD card where your backup file is saved.
  7. Select the backup file you wish to restore.

    Once selected, your selection will be highlighted.

  8. Press Select to confirm your backup file selection.

    A Restore backup pop-up will appear:

    • Select Yes to replace all current page configurations and system settings with those found on the backup file.

    • Select No to cancel the file restoration process and return to the file browser.

Once restored, a Backup restored pop-up will appear at the top of your screen.

Note

If you are experiencing issues, refer to the troubleshooting advice found within the following section: Troubleshooting